top of page

Seats (reupholster):

I Got the Park Lane Classic full seat kit (Foams, foam-boards, Covers, head rest, arm rest, some extra

clips, and tail boards. I made a "CAD" print of the Tail Boards/clips since most tail boards don't survive.

Amazon of course had a set of Carbon fiber heated seats with two heat settings, that will be added and just

use the top one since neither me nor my woman like the butt warmers. Here is a pic of the Tail boards, the drawings is on the MISC page as a PDF.

Got my Seat tail boards in today from Pa
001 Runners for the seat rails.jpg
004 seat heater elements.jpg
003 Seat side bolster clip boards.jpg
002 double sided tape for runner spacers
04 Seat Frame-baskets-slides-head rest r
007 burlap on bottom.jpg
006 seat bottom foam top.jpg
005 seat bottom frames-bottom foams-head
008 front seat foam bottom.jpg
009 seat bottom glueing.jpg
011 drivers side bottom done under.jpg
010 putting in nylon bolster at edge.jpg
012 drivers side bottom done.jpg
013 seat frames with custom squabs made.
014 marking where to glue for back foam.
015 seat foam glued onto back frame.jpg
016 back seat heater element glued in.jp
017 side bolster board place and hook cu
018 Middle seam pull sheet tensioned.jpg
019 Middle seam pull sheet clipped.jpg
020 runner spacers attached to runners.j
021 My bud Rob working on a head rest co
022 seat done front view.jpg
023 seat done left side view.jpg
025 seat done right side view view.jpg
024 seat done rear view.jpg
026 Seats are in.jpg
bottom of page